

Red Electric wire butt connector for Copper Cable 1.5mmq PL-03M 10PCS

10 Red head-to-head electric connector for copper cables 1.5 mmq type PL-03M
The joints of the PL series are specifically designed for use on flexible cables. They are made from Cu-OF CW008A electrolytic copper tube according to UNI EN 13600: 2003. Annealed and protected on the surface by electrolytic tin plating, min. 3μm. The annealing process optimizes the structural characteristics of the material, therefore allows easier compression and guarantees the use of the joint in the presence of mechanical stresses of various kinds. the PVC insulating coating simplifies the installation and restoration of the cable insulation. The insulating blouse also embraces the cable and prevents it from bending too abruptly at the mouth of the joint, helping to increase its resistance to mechanical stress that could damage the elementary wires of the conductor.
Main features of PVC insulated blouses:
- DIELECTRIC RIGIDITY (KV / mm):> 35
- SPECIFIC VOLUME RESISTANCE (Ω / cm):> 1015
- TEMP. MAXIMUM WORKING (°C): 80
- FLAMMABILITY (UL-94): V0
- DENSITY (g / cm3): 1.4
- ABSORPTION of H2O (%): 0.1 ÷ 0.6
- BREAKING STRENGTH (N / mm2): 45 ÷ 50
• The couplings can be used within the following temperature ranges: - 20 ÷ + 80 ° C (+ 90 ° C for short transients).
• The joints can be stored at a minimum temperature not lower than - 40 ° C.
Pack of 10 pieces.
10 other products in the same category:


Mobile terminal block 1 hole 4sqmm 10 pieces

Watertight shunt box 3 input 76x127x45 mm

RF-M5 Red terminal with eye for copper...

GF-M6 Yellow Terminal with eye for Copper...

Heater for heat-shrink sheath 220V 1500W

Electrical cable terminal for 6 terminals 30A

Terminal board 10 terminals Capacity 20A

Watertight shunt box 6 input 140x100x53mm

Reviews (0)